About MortenBjor

MortenBjor · 10-16-2013

My Cisco 2921 came shipped with two preinstalled VWIC3-2MFT-T1/E1, and I had no problems adding it as MGCP gateway to my new CUCM BE6000 version 9.1. However, even though both VWIC3's appear nicely at show inventory, they seem completely dead. All LE...

MortenBjor · 10-17-2013

Problem solved !George Thomas helped med bringing up the VWI3's, (see post above).But the lack of ISDN commands was due to a missing license accept. After accepting EULA and a reboot, all cannels came up, and commands show isdn status and debug isdn ...

MortenBjor · 10-16-2013

Thanks George, that helped. VWIC's came up with LEDs, but still no ISDN related commands seems to be valid. I've triedshow isdn statusdebug isdn q931Service Engine is in shutdown status. I didn't think that could have anything to do with this, but no...

MortenBjor · 10-02-2012

Hi Jesus, I found the CUCMBE 9.0 Ordering Guide here:http://www.cisco.com/web/partners/downloads/partner/WWChannels/technology/ipc/downloads/be_6000_version.pdf

Member Since	‎09-23-2008 02:49 AM
Date Last Visited	‎06-19-2019 12:35 AM
Posts	4

User Statistics

User Activity

Two VWIC3-2MFT's won't wake up in a 2921 router

Two VWIC3-2MFT's won't wake up in a 2921 router

Two VWIC3-2MFT's won't wake up in a 2921 router

Migrating from CallManager 4 to CUCMBE 9