Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
In my topo i have 02 psn node (psn1, psn2) and haven't any loadbancer device.
On switch, configured radius-sever with psn1 - priority 1, psn2 - priority 2 so switch can connect to psn1 first.
On PC i have AnyConnect agent and Compliant m...
Hi all,
I know that ISE deployment phase should be Monitor Mode first and then Low-Impact Mode or Closed mode.
In Monitor Mode the authentication open command needed to be applied to the switch port on Cisco switch. But i don't know on HP Comware sw...
Hello everyone,
Do you have resolved this issue, i have same the issue:
"I need config AnyConnect profile to AnyConnect agent can connect psn1 first, if psn1 fail then connect to psn2 because i have got issue: when PC connect, firstly swicth connect ...
Hi,I need config AnyConnect profile to AnyConnect agent can connect psn1 first, if psn1 fail then connect to psn2 because i have got issue: when PC connect, firstly swicth connect to psn1 to authenticate after authentication successful anyconnect con...
