ISE 2.4 Deployment phase - Monitor mode with third-party switch

[hiepnguyen991]

Hi all,

I know that ISE deployment phase should be Monitor Mode first and then Low-Impact Mode or Closed mode.

In Monitor Mode the authentication open command needed to be applied to the switch port on Cisco switch. But i don't know on HP Comware switch.

Can you help me how to configure in Monitor mode or phased approach on HP Comware switch.

Many thanks,

[Arne Bier]

Have you asked this question on an HPE forum or perhaps on an Aruba forum? (you might get lucky or be re-directed by someone on the Aruba Airheads forum).

[hiepnguyen991]

Thanks bro,