Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have very large 11gig ftp transfers from my customers that happen every night. These are taking 8 plus hours. I have 100 meg and customer has full DS3. Neither is even close to half. I have on "inspect ftp" could this be slowing down the transfe...
I am trying Dynamic NAT to work on 7206. I am using this on my VRF interface. I was able to get static to work, but my MPLS cloud has 30 enpoints and I want all of them to share the same public IP. I will attach my config.10.20.20.21 is the MPLS s...
ASA 5520 failing over just fine. My issue is that I want the primary ASA to become acitve after its back on line. I cant find any commands that bring the Primary unit back up to acitve after it fails, I know I can get it back manually, but it reall...
I want to set up Active/Standby stateful failover. I only have 4 interfaces and 1 mgmt port. I have a outside, inside, and DMZ port configured. I want to use the last port for the stateful information and the MGMT port for the failover information...
The internet is at both sites with 7200s. I did see that the ASA can do ip sla tracking, but its only for default routes. Since these are going to be at different locations, I need to be able to track the inside route as well. Any guidance is appre...
Jon-If they were in the same subnets could you? I have 10 gig between my datacenters. I think you can, my issue would be detecting what types of failover. Can you track for failover purposes? I can loose internet link, but the link stays up? Than...
I opened up a case and found the answer.Restrictions for Integrating NAT with MPLS VPNs Inside VPN to VPN with NAT is not supported. http://www.cisco.com/en/US/docs/ios/ipaddr/configuration/guide/iadnat_mpls_vpns_ps6350_TSD_Products_Configuration_Gui...
Wow, i didn't think anyone would get back to me on this!I would like to use my MGMT port for my management network, but I have never used the same cable for both failover functions. I know the gig port will not even get close to getting saturated. ...
