About jeff

jeff · 07-06-2005

I've been looking over a PIX firewall that has version 4.4 of the OS. I'm confused as to what the following lines are allowing:static (inside,outside) pub.80.45.64 172.16.20.153 netmask 255.255.255.255 0 0conduit permit tcp host pub.80.45.64 pub.153....

jeff · 06-25-2004

I have a client who has a Tiara Networks 1400 unit which bonds T1 circuits together. I would like to replace this with a Cisco unit. What technology, or hardware does Cisco offer to do this?Thanks for any help.Jeff

jeff · 06-16-2004

We have a PIX 515e with six interfaces. One interface is the DMZ with public addressing. One of the other interfaces is the inside which is using private addressing. The command below disables translation for the DMZ network because all servers are p...

jeff · 05-17-2004

I have a PIX 515e with six interfaces. One interface is configured for standby, one for outside and the other 4 for different subnets and DMZs. All interfaces except the standby have public IP addresses that have a small public IP class on each one. ...

jeff · 05-10-2004

I have a PIX 515e with six interfaces. One interface is configured for standby, one for outside and the other 4 for different subnets and DMZs. All interfaces except the standby have public IP addresses that have a small public IP class on each one. ...

jeff · 07-07-2005

Thank you for the posts. The information is perfect and now I understand.Thanks again,Jeff

jeff · 08-24-2004

I have a Cisco router running aaa new-model authentication with local usernames. I have a username that I would like to have only access to the exec prompt only with the ability to execute the show run command. I've tried the suggestions in this thre...

jeff · 06-27-2004

Thanks for the reply.Jeff

jeff · 06-26-2004

Thanks for the reply.Does the other end of the circuits, let's say the ISP side, have to configure PPP on their equipment for this to work?BTW. Is this MLPP?Thanks again.Jeff

jeff · 06-17-2004

Thanks for the reply.The default gateway for the servers on the DMZ and inside interface is this PIX. Servers destined for the outside from the inside have a static translation already set.Thanks again.Jeff

Member Since	‎11-20-2001 02:02 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	72

User Statistics

User Activity

Confused with a conduit statement

Cisco T1 Bonding Hardware?

PIX Question regarding Private Addressing

PIX with Public Interfaces & One Private Int. Question

PIX configuration with Public & Private addresses

Re: Confused with a conduit statement

Re: Can I disable some commands to privilege level 2 users?

Re: Cisco T1 Bonding Hardware?

Re: Cisco T1 Bonding Hardware?

Re: PIX Question regarding Private Addressing