Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Radim,
thanks for your observation, i have added the ip pim sparse-dense-mode commands in Vif1 and Gi0/0 interfaces. i also want to know before i test with the added config.........where am i suppose to configure multicast? on my access switch ...
yes i have two 7975 phone on a CUCM, integrated with the IPICS server, i have a cable connecting the GM300 radio to the E&M port on my RMS.
i can push a call from the DC to the IPphones but when i patch the radio channel, no signal.
first you need to get an interface cable from this site: http://networkedradio.com/ then the configuration, you can find a step by step from the SRND guide doc.
i have a GM-300 radio with the interface cable to the E&M port, i've done the config step...
hi,
your LMR (Land Mobile Radio) should be the base station Radio. there is an interface cable between the LMR and the RMS E&M port....depending on the type of radio you intend to use....the interface cable are of different types.