About justin-burley

justin-burley · 01-15-2016

I have three cisco Rv082 switches connecting to load balancing draytek vigor 300b Problem is I have advanced routing (static routing) configured as, ip address range, gateway of Wan port of the destination cisco switch. I have not added any static ...

justin-burley · 02-16-2016

Hello Phil, We have these set and have been for some time. These routes are not allowing data to reach the ip address chosen. It says that the route is filtered. I do not know why as the firewall is disabled. If the firewall is disabled all data sh...

justin-burley · 02-11-2016

Hi Philip, I am still having trouble setting up the static route. I have attached a schema of the network and we have removed the firewall on the internal network cisco rv082 switches. You can not see with ping any of the other switches. I have set ...

justin-burley · 01-17-2016

Perfect thats what I thought many thanks

justin-burley · 01-17-2016

I understand that would be for all data udp... I shall setup the firewall rule for that and see what happens tomorrow. Thanks for the input.

justin-burley · 01-17-2016

I have attached a basic diagram of the network

Member Since	‎01-15-2016 01:29 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	6

User Statistics

User Activity

Static routing via the wan to lan ports on Cisco RV082

Hello Phil,

Hi Philip,

Perfect thats what I thought

I understand that would be

I have attached a basic