Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi @HMHNetwork , @Mark Elsen ,Hope everything is fine on your end. Assuming this could be an error from bootflash being in Read-Only, could you share the result of:
show diagnostic result module 1 test 6 detailshow hardware internal bootflash model
...
Hello @shlomoi , Seeing this thread, not sure if the device is stuck in boot loop.
Wondering if the below would help ?
install all nxos bootflash:nxos64-cs.10.4.5.M.bin bios-force
Please let us know if this answer helps you. Have a nice dayKind Rega...
Hi @MD-Shoar
Hope you are doing well. The below can helps you to troubleshoot your incident and about FX2 temperature threshold.
In the "show logging nvram", there should be also some logs regarding temperature event/shutdown of the switch if it wa...
Hi @sep.k , Yes, as far as I know, S-A9K-400G-ENABLE is not enforced and there should be a license on the CSSM. Might need to run 7.9.1 to get this correctly consumed.Please, let me know if this answer helps you.
Have a nice dayKind Regards,Antoine
Hello @sep.k , Hope everything is fine on your end.
S-XRV-ROUTE-T4 doesn't require smart account. Allow me some time to get this corrected. Please, let me know if this answer helps you. Have a nice dayKind Regards,
Antoine
