Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,could one of you take a look at my configuration. I am trying to set up dual WAN load balancing on my Cisco 1111 router. However, I do not manage to do it. The computer gets assigned an IP address using DHCP, but cannot access any website. A pi...
Hello,I have a question. Currently I am trying to configure my new Cisco 1111 router.Now to my problem:I have two internet connections from two ISP. I would like to bundle both connections and get a load balancing, and therefore also reach the double...
Hello,I have a problem. I have a Cisco 2702i AP with two wifis. The two networks run on 2.4GHz and 5GHz and so far work without problems.But as soon as I connect my Apple TV to the wifi, it triggers the following error message and then loses connecti...
Hello,unfortunately, I am not getting anywhere with my problem right now. I have a Cisco 2960-C switch and a Cisco 2702 AP. On the switch I have on Gig1 (WAN1) and on Gig2 (WAN2). Now I want to make a vlan for WAN1 and a vlan for Wan 2. In this case ...
Hello.I have a Cisco 2702I access point, and would like to use the second LAN port as a second interface + wifi network.Would this be possible in any way? I haven't found a way to do it, and I can' t find any documentation about it on the internet. T...
Hello,thank you for your help.But it still doesn't work, unfortunately.You wrote: "ip route 8.8.4.4 255.255.255 GigabitEthernet0/1" - but I don't have this interface.I think you mean GigabitEthernet0/0/1 instead?ThanksAlex
Hello again,I have uploaded my current Config again in the attachment. Maybe someone of you will find an error.The vlans work without problems, but I am not able to come externally. A ping from the router to 8.8.8.8 also fails. I think there is a pr...
Hello,thank you very much for your help! But it does not want to work.Attached again the current config, maybe I have an error somewhere?Current configuration : 6744 bytes!! Last configuration change at 14:15:08 UTC Mon Jan 16 2023 by webui!version 1...
