Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllI am trying to configure ssh access to my 4506 switch. Does anyone know which version image supports ssh because my present version does not seem to support it. I cannot get the "sh crypto" or "sh rsa ... " commands going?Thanks.THANKSSWITCH#...
Hi EveryoneI created an etherchannel on two ports (2960 switch) and placed them into an etherchannel. Did the same on the other switch Cisco 3020 blade chassis switch. Without connecting any cables the 2960 had done an up/down sequence as though a ...
Hi Everyone out there.I have a situation that I need someone to explain what could have happened. I have a 2960 switch which was having a vlan flapping problem in one vlan - lets call it vlan 200. I was preparing to connect some more switches into ...
KAThe errs come this way. When you configure an etherchannel between two switches, you do it one at a time, right. As long as they are connected, at one moment one switch will have the config and the other will not - that is where the "misconfig" i...
Hi NormanI think you are right. Thanks for that. The response came late, but I think it is because we already having some vlan flapping issues on that switch.Fantastic - thanks again.Sydney
Hi NormanThis might help explain: After creating an etherchannel and placed ports in it and performing a "no shut" the switch produced a response as below WITHOUT any cables connected to the port:21w3d: %LINK-3-UPDOWN: Interface GigabitEthernet0/14...
Yes it is down now. Only problem is we are trying to establish what caused it to come up with no cable connected. Because during the same time, looks like STP re-converged and we lost a few services in the affected vlan.
