Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,
Currently I am working with the customer who had deployed wired dot1x in their environment, As they have some of the switches which does not support IBNS 2.0 they are currently going ahead with IBNS 1.0 implementation at this point.
We h...
Thanks Mate,
Yes reversing order is another option but I was wondering is changing advance settings for dot1x is going to address this issue permanently or temporarily and if this is suggested by ISE Team.
Regards,
Parm
Hi,My apologies for the incorrect information, I recreated this issue and Prem is correct, we cannot configure radius accounting for the commands. Tacacs is the only option available for the command accounting.ThanksParminder
Hi,That is very much possible but I am not sure if IAS logging supports it. Here are the commands we need to configure on IOS devcie.aaa accounting exec default start-stop group tacacs+aaa accounting commands 0 default start-stop group tacacs+/Radius...
Not directly, you have to configure some NAS in between like pix, but again that would not be resource based access. PIX would check IP and then end out authentication request to ACS.In other words. Answer is No. I cannot think of any scenario where ...
First of all, if you have exec command and shell priv option checked you should be in # prompt, you should not be following in user> mode. Please send the following debugs when trying authentication.-debug aaa authentication-debug aaa authorization-d...
