Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,I am wondering if CME POTS dial-peer has '#' sign as its default termination key.I found in CME VOIP dial-peer, it will recognize '#' as default termination key which stop T302 timeout timing.ie, I have dial-peer voice 999 voip destiantion-pat...
This scenario took me quite a while and still no luck.One co-resident CME-A gateway/ H.323 gatekeeper in same cisco rtr, and one other CME-B gateway. ephones under CME-A cannot connect to CME-B via gatekeeper, CME-B ephone cannot talk to A vise versa...
PhoneA x8012 call PhoneB x8011, connected, then phonB place call on hold, phoneA didn't hear MoH music (music-on-hold.au) but just regular beep.MOH music not playing when call onholdIOS: c2600-ipvoice-mz.124-5c.binTelephony-service: 3.3Hardware: 2651...
Today, I observe this situation which prove Cisco MGCP Callmanager route list won't failover to 2nd route group when the 1st route group's T1 circuit is down.Ie, RoutePattern 9.@ -> RouteList: RL_siteA -> Two RouteGroup: VGW1_T1 and VGW2_T2 which in ...
Yes - I forget it is 2821 rtr which should use PVDM II resource other than PVDM I. So my previous sample configure is for PVDM I. For PVDM II, then 2nd sample is good.Good to know your question been answered!James
SO in your AA callhandler, you need to config one input key say '3', then setup its action to be: 'send caller to - caller system transfer', then caller will be able to dial no-unity-subscriber number.However, Unity restriction table will still audit...
I have verified the setup in my environment and got it working.Points here:********************1. Since this site phones been controller by local H323 vgw, they need local dsp xcode resource to do the job but no from CCM.2. Ensure local DSP resource ...
