Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I've got 2811 with CCME. All ephones, including CIPC, in the local LAN and not so remote WAN segments are working quite well. There isn't much load on the router, only 5 ephones total, it's just a starting project.Recently we needed to provide te...
Hi, is there any way to assign ip for nhrp spoke tunnel interface dynamically from the hub?I'm talking about that scenario:http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008014bcd7.shtml
Hi, i have a problem with OSPF on PPP link.I made a pptp server on 2801:!vpdn-group pptp! Default PPTP VPDN group accept-dialin protocol pptp virtual-template 2!interface Loopback2 ip address 10.35.14.1 255.255.255.255!interface Virtual-Template2 i...
I have a PIX-515E, Software Version 7.2(1) with NAT disabled, in router mode, and almost all inspection off. REcently i noticed that PIX randomizing TCP sequence in ICMP Frag embedded message, that is last 4 bytes of the packet. Looks like windows ho...
Maybe there is some other way co connect branches, which might have dynamic external IP's to central office with OSPF support?I've also tried l2tp, but OSPF and PPP are not good friends.
After checking once again, i found that mpd host doesn't receive routes at all at this setup.if i configure virtual-template on server with ip address 10.35.14.0 255.255.255.0only then mpd host receives routes, but that makes connection from other ho...
