Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i am currently researching information about ASR series on a speciffic hardware setup. the information found so far is not stated in official cisco documentation and through this way i'd like some additional input.hardware config:1x ASR10061x ESP2...
Hi all,We are experiencing an issue which seems to contradict itself on a stack of 3 switches. The issue we are seeing does not seem to be very well described in the Cisco documentation, if merely shows the status exists, but not if it's good or bad...
Hi Leo,Thank you for the reply, i'm aware of the ESP20 throughput and as noted earlier i'm not looking for this exact info. Please see my reply to Joseph for the actual question. this refers to the ASR1006 and in speciffic the document noted in my or...
Hi Joseph,Thank you for your reply, it's helpfull but not entirely what i was looking for.Also in your example you seem to explain 20G in and 20G out, but the following document seems to indicate otherwise: http://www.cisco.com/web/SK/expo2009/docs/c...
Hi Leo,thank you for the quick reply, though i may have asked the question in a wrong context.the question lies in the following : ESP-20G: 2 x 11.5G ESI to two SIP slots; 1 x 11.5G to third SIP slotis the third slot limited to half the bandwith, bei...
hi,thanks for your reply, indeed that output had me wondering if it was relating to the issue i'm having.as far as proof goes, i've seen pretty much all Cisco documentation and indeed also noticed this status in the documentation, but it did not note...