Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,> > I am trying to do WCCP from my 6513 to a Web Proxy server but not able due> to VRF lite issues.> I am was wondering if the Nexus 2K or 4K can act as a load balancer and> redirect ports 80,443, and 21?> I will put the Nexus switch in between...
Could anyone please help. I recently installed a PIX 5520 with AIP-SSM-10. I can manage the sensor just fine and am using "configuring Cisco IPS using CLI 6.0" as a reference. I recently downloaded new signatures as sig1 on my sensor. when I enable...
So just to confirm I can use a copper 1000BASE-T SFP in a Nexus 5010 as long as its in the first 8 ports? I am running on my Nexus: kickstart: version 5.2(1)N1(7)system: version 5.2(1)N1(7)SW1SAN-SW001# sh interface ethernet 1/6 capabEthernet1/6 ...
Thanks very much, I will give that a go. I also read that the sensor should be in learning mode for a few days. What is your opinion and have you had any luck with that?
