Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello to everybody,
how can I send syslog for connection events (not Intrusion events) to an external syslog server?Which facility and severity do have I set on Alerts configuration?
Thanks in advanceLore
Hello to everybody,
I have a question about the updates on Device managed and Defense Center.
If I schedule the update of VDB, Snort Rules and Geolocation IP Address, on Primary Defense Center; I have to schedule in Secondary Defense Center too? Or ...
Hello to everyone,
what about to apply an Access Control Policy with some rules and some Intrusion Prevention Policy in an architecture where the ips is deployed in passive mode with a mirror port?!
Is it advisable?
thank you in advance
lore
Hello to everyone,
I have an architecture with a FP8120 that works like sensor... In this phase we are going to tuning it with some rules. The environment is a Finance Institute that have to be compliance with the PCI DSS.
Is there any suggestions, t...
Hello to everybody,
I'm trying to install properly the DC200. I'm trying to connect in the serial console port, but with some problems...
Please, see the image in attachment:
1) Which is the difference between ports 6 and 7? Both are management inte...
Hello Pujita,
Thank you for your response.
I meant if is make sense to do some ACP and IPP in a passive deployment (for a future put in Inline mode).
Regards,
Lore
