About dkellyusi

dkellyusi · 07-10-2017

Hello all, I'm running all Allen Bradley Stratix Industrial switches, which are essentially rebranded Cisco IE switches. But, the principles should still be the same. Here's my topology: 1x Stratix 5410 (Cisco IE 4010) Layer 3 switch as Core Switch ...

dkellyusi · 06-07-2017

Hello all, I'm running all Allen Bradley Stratix Industrial switches, which are essentially rebranded Cisco IE switches. But, the principles should still be the same. Here's my topology: 1x Stratix 5410 (Cisco IE 4010) Layer 3 switch as Core Switch ...

dkellyusi · 03-30-2016

Hey all! My head hurts from trying to figure this out. I have an L3 Core Switch (Allen Bradley 5400 running IOS) I have several VLAN's, one of which is Management (vlan 10) where I can plug in my laptop to access all other VLAN's and their devices u...

dkellyusi · 06-07-2017

Also, not sure what device is doing the NAT, but if it is the corporate network device, than you need to add 192.168.10.0/24 to the NAT statements, so it can reach the Internet. Yes, the Corporate Network Gateway handles the NAT. With most of my ...

dkellyusi · 03-31-2016

Thanks to you both! I knew it was something dumb I was overlooking. I added a static route to 192.168.10.0/24 via 192.168.1.254 on my Gateway device (192.168.1.1). Thanks again!

dkellyusi · 03-30-2016

Thanks for your reply, John Yes, gateway is plugged into Gi1/1, interface is up, and I can ping the gateway 192.168.1.1 from the router. I can also ping external IPs from the router (e.g. 8.8.8.8) which means that the gateway is working, too. So p...

Member Since	‎01-25-2016 12:32 PM
Date Last Visited	‎12-14-2017 12:02 AM
Posts	6

User Statistics

User Activity

Deny Internet Access from all VLAN's except 1 from L3 switch

Inter-VLAN routing plus Internet with L3 Switch

[SOLVED] Can't get a route to Internet with L3 IE Switch

Also, not sure what device is

Thanks to you both! I knew

Thanks for your reply, John