Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a C90 running firmware version TC7.3.2.14ad7cc.On our older 6000MXP Units there is an option in permissions to set "Allow Incoming Audio Only Calls" to "Off". I would like to do so with our C90 has started to get random robo h.323 calls.We do...
We recently had a WebEX Room Kit Pro with a QuadCam installed. Our setup uses a stage rather than a conference table. Currently when the QuadCam tracking is turned on it operates with a closeup snap to the speaker after they have moved positions. Is...
Our university has recently added Zoom to our service list. We currently are an o365 campus and have a Cisco C90. We would like to tie our C90 into the Zoom service with their Cisco Room Connector. The trouble I am having is that one of the prerequis...
We recently had a Cisco TelePresence Profile 65 system donated. We did not get any documentation and I have been unable to locate instructions for the lcd screen. The screen has several inputs and RS232. I would like to figure out how to change the s...
We recently had a Cisco TelePresence Profile 65 system donated. We did not get any documentation and I have been unable to locate instructions for the lcd screen. The screen has several inputs and RS232. I would like to figure out how to change the s...
I was afraid of that. I think the installer may have elected to provide us with the wrong model camera. Iv'e seen demo's videos in the past where the camera will follow track (digitally or optically i don't know) Can someone tell me what the correct ...
After more conversations with Zoom Support it appears I have been misunderstanding how this works. Direct integration between 0365 and the C90 does not happen. Sorry for the post. But for those who might be looking into this, the Zoom plugin bridges ...
Thank you very much for providing those links and the information. This is our first experience with the Profile series equipment. Its good to know that it wasn't designed to operate independently.
I went ahead ad tried the update. I left the release key field blank. The Tandberg reused the stored release key from its last update. The update went without a hitch. Thanks Mubashshir for that suggestion. Now its a matter of time to see if this re...
