Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi Team
i have FTD 4120 where MGMT interface available to manage Chassis.
can i assign that MGMT interface to other onboard available interface
regards,
darshin
Hi Team
i have configured two separate VRF for VLAN 30 & 40 and apply VRF leaking for same but still communication unable to happen.
also routes are showing in respective VRF routing table.
configuration as below.
vlan 1,10,20,30,40
vrf context BL...
SMTP traffic need to hit translate in private IP address.
===================================================================================================
InBisco-AHM-ASA5512-FW(config)# sh run natnat (DMZ-Apps,outside) source static DMZ-APP-SRV D...
HI Team
I have IP SLA configured with single IP track as below.
sla monitor 10 type echo protocol ipIcmpEcho 8.8.8.8 interface OUTSIDE_PRIMARY frequency 20
can i apply using AND OR condition of multiple track IP?
Regards,
Darshin
also route information as below for VRF..
switch(config)# sh ip route blue ^% Invalid command at '^' marker.switch(config)# sh ip route vrf blueIP Route Table for VRF "BLUE"'*' denotes best ucast next-hop'**' denotes best mcast next-hop'[x/y]' denot...
HI
Public IP is 111.93.94.253 and private mail server IP is 10.150.8.14.
now outgoing and incoming both are not working.
above packet-tracer output are there.
and below is show ip.
InBisco-AHM-ASA5512-FW(config)# sh ipSystem IP Addresses:Interfac...
