Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a Cisco FTD managed by FMC running software version 7.6. Remote users connect to the FTD using RA VPN. The VPN clients can successfully access permitted resources inside the local network behind the FTD.However, there is a requirement to...
Hello,I currently have a Cisco FTD managed by FMC version 7.6 with a configured and operational remote access VPN connection (SecureClient) on three separate external interfaces (three ISPs).I've added a second identical FTD to FMC and need to create...
HelloI'm experiencing DNS resolution issues with Remote Access VPN configured on Cisco FMC version 7.4Cisco Secure Client connects successfully to FTD managed by FMC. Authentication passes without issues.Client receives:- Correct IP address from VPN ...
Hello,I have a Cisco Firepower 1150 running firmware version 7.6 with three connections to different ISPs.I want to set up Remote Access VPN (AnyConnect), but I encountered a limitation: Firepower only allows configuring VPN on a single external inte...
I have an ASA 5516-X witch firmware version 9.16(4)I'm trying to configure aaa-server on the ASASpoileraaa-server ISE protocol radiusinterim-accounting-updateaaa-server ISE (mgmt) host 172.16.1.100key *****authentification-port 1812accounting-port 18...
You were right.I changed "DNS Request Split Tunneling" policy to "Always send DNS requests over tunnel."This solved the problem.Thank you for your help.
I configured the inside interface instead of the mgmt interface. The result is the same. The inside interfaces have the management-access command. There is a route to ISE via vti. I can ping from a host on the 10.10.200.0 network to ISE But packet-tr...
ASA can't use VTI name to configure aaa-server.I have tried to use nameif outside1 as interface to connect to ISE. Also I have changed nameif magmt to inside1.The resule is the same.
I'm trying to find two users and typing user's names. Jabber sends requests to CUCM node. One user's request returns all information about user. Another user's request returns "found 0 records"There are both users in End User list on CUCM.
