Hi all, I have facing the problem in branch site , we have branches connected to HO by lease line and the failover is ISDN . i have configured pri timeslot and dailer at HO also configured BRI and serial INT at branch site .but the probl...
Hi all, pls find the attachement , i have problem regarding switch redundany if we coonect two uplink from one switch than there is loop occured so by what configuration we can avoid the loop , or give any example to check it.Thanks
Hi, I have one 2851 router with HWIC-2CE1T1-PRI at HO side and three 1841 at branch side with bri and serial interfaces . i want to configure lease line as a primariry and isdn pri /bri as a backup link . HO and branch are point to point .I am...
Hi dear, pls help regarding lease line config and isdn configi have one 2851 router at head office and 1841 at branch office , so we have to configure primary lease line and backup isdn line ,pls give any example of configuration and sam...
Hi Richard , thanks for your needfull reply , i have allerady configured dailer string at branch site and check the test call by shutdown the modem.test call completed but auto failover not happened . if you have example con...
Dear Omid , I have facing same problem , the case is that I have one router 3845 with NM-2ce1t1-pri. now we have to install new HWIC-2CE1T1-PRIand change the IOS to 12.24 (20)T but card is not detect what can i do ?Card is ok becau...
hi right now i m outside the office ,so we can not give sh int , there are 4 LAN and 1 wan ADSL port , the wan port is not connected.when we connect by console wan interface shows Ethernet is up but line protocol is down