Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a CME 7.0 and registered a small analog gateway (like and ATA with 2 FXS ports). Is registered via SIP on the CME. Registration woks fine. I can make and receive call on the analog phones attached to the FXS ports.I have also configure...
I have a Call Manager 7.0 registered with Grandstream GXP 2010 SIP phones.I have created a router pattern to use the FAC, but when a dial a number that uses the the route pattern with the FAC, there is no tone to enter the code.Eventually the call fa...
Hi,I have installed a Call Manager 7.0 and activated the intercom feature, but my client needs this feature to be able to work for a group of phones, instead of just a single phone.For example, if a user wants to spread a company wide message via int...
Hi,I have a client that complaint that his CSS device los connetivity a couple of times, causing service interruptions.I went to check the device log (syslog.log) and found the following messages for the day that the problem ocurred:System initializa...
Hi, I have a CSS 11500 installed on a client's site performing load load balancing for 4 servers. Its also using SSL termination module.The content rule is configured as follows :content servers url "/*" protocol tcp port 80 advanced-...
I have performed a debug on the dial-peer to get that information.Also, as you menthioned on you email, I have set up a loopback voip DP.This configuration works fine if I register the device (analog gateway with 2 FXS) on a call manager as third-par...
How and where on the script I will define these arguments if I were to configure it in the script itself ?Pardon my ingnorance, I'm new to CSS and scripts.Thank
OK Gilles, I understand the part of the 3 arguments, but based on my configuration and the parameters I'm using this will be ?keepalive type script ap-kal-httptagban "192.168.249.3 /bancasa/start.swe?SWECmd=Logoff www2.bhd.com.do"is this command ok ?...
Gilles:I know this is a two years old, but need some help with the issue regarding this post. I need to have a script keepalive to verify the content of a page. I tried what you mentioned here, but my service won't come up. My set up is this:SERVICEs...
