Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have (3) switches which are connected together in a redundant configuration. The connection between the SludgeBLDG and DigestBLDG switches are using ports Gig1/0/3-4. I have manually set the port cost for all VLANs to 100 but am still unable to con...
Hello Cisco Community, I have a brief question regarding the setup of RSPAN via multiple intermediary switches. I am familiar with setting up an RSPAN session between (2) switches, however, when there is a switch in the middle of those two switches -...
Does the Cisco IE3300 support assigning IP addresses to drives and PLC's via DHCP persistence? I have had quite the time finding a definitive answer. I have experience using it with the Stratix 5700 line of switches but never the IE3300 and an not su...
Hi Cisco Community, I am setting up a network in Packet Tracer and am having issues with my pc's, which are all on different VLANs, from pinging the router. Below is a screenshot of my current config. My goal is to route between the different VLANs u...
Martin - Thank you for taking a look at the attached file. Yes - I verified and the spanning-tree vlan 200 cost 100 command on Gig1/0/4 was a typo that I had missed. Thank you for bringing it to my attention. When I actually head out to field deploy ...
Martin, Yes - I am using the latest version of Packet Tracer. I have attached the PT file for you with a brief explanation (in addition to this long thread) in the PT file. I believe I am over-complicating it and have successfully configured it. Than...
I appreciate your help. I am not only relying on your expertise but am still trying to figure it out on my own. Perhaps I should have made a copy and worked from there. Thank You.
Here is the info for both switches. I only included VLAN 1 but all subsequent VLANs are setup exactly the same. SludgeBldg3850#sh spanning-treeVLAN0001Spanning tree enabled protocol rstpRoot ID Priority 8193Address 0002.17BE.A6E2Cost 4Port 1(GigabitE...
Still not able to get the intended result. It is possible that I cannot completely block the entire link between SludgeBLDG and DigestBLDG? I was able to block both ports Gig1/0/3-4 on DigestBDLG which are connected to SludgeBLDG. Essentially, this w...
