Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an L3out connected to a firewall with OSPF configured in a normal area which is not 0. I am learning all of the area routes as expected. Is it possible to summarize the routes to the spine switches/other leaf switches in ACI?Firewall (OSPF Are...
Question on TLOC preference. Quick diagram attached.If private1 is set to higher TLOC preference, can it cause issue routing to sites that only have public-internet?For example:R1 should always route traffic across private1 to R3 and vice-versa.R1 sh...
I am running an API call using 20.9.3 and 20.12.1. I am trying to do /certificate/device/stage. The purpose is to stop data traffic by placing certificate of the device in staging mode. I am getting 405 Method Not Allowed. I am able to successfully g...
So sites 1 and 2 can talk to 3, and sites 1 and 2 can talk to 4. Even though MPLS is preferred on sites 1 and 2, the site with only internet is still reachable?
One thing that I did find out is that the normal OSPF rules of all routes in one area are learned on all routers in that area apply. ACI will not let you get around the rules of OSPF.
Here is a diagram of what I am trying to accomplish. I just want to make sure that after I apply the preference: 1. A site talking to another site where each site have MPLS circuits, use the MPLS circuit both directions (symmetric)2. A site talking t...
This is what I am trying to accomplish. I am just wanting to apply preference on all internet circuits and MPLS circuits. However, some sites only have internet circuits. I do not want to break traffic to a site that does not have MPLS.
