Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello everyone,
I have enabled igmp snooping on pair nexus switches, and one of the switches logs shows the following (show ip igmp snooping event-history vlan ), what is the meaning of the first line ?
2022 Oct 27 14:41:23.185364 igmp [8299]: [84...
Hi Expert,
I am new to Cisco DCNM and would like to know if it is possible to restrict a user from accessing the template library so he can not modify the templates such VRFs etc.
Regards
Dear All,
Can I point all switches to one querier in the l2 multicast network? Attached is the sample topology with each device config pointing to one switch NXOS1, which is the querier, or other devices will discover the querier NSOX1 via IGMP sno...
Hello Experts,
I am using NX9K version 9.3(3), and I want to enable IGMP querier for L2 multicast, but I can't find the command,
please see the attached picture and kindly advise!
Regards
Hi experts,
If anyone can answer this as I am a bit not clear how the SW as a system updates itself against the latest threats available on the internet ? without any Talos or ETA type implementation, only in the standalone environment where only F...
i am planning to implement the IGMP queirer on the Nexus but i would like to if it would interrupt any traffic or affect the service in the the target, i am sure pretty sure it wont
I have four switches, and all four Switches have SVI for Vlan 600 with igmp snooping enabled on it, is IGMP Querier still required?
With SVIs on all four switches, it is a routed network now, and according to the guides as mentioned below, "With IGMP...
the application which uses the multicast address of 230.1.2.3 " Multicast IP addresses are used for one-to-many and many-to-many communication over an IP network".
The application has sender and receiver for sending messages from sender to receiver v...
