Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I would like to know if it's possible to do the same setting like this one but with dhcp gateway ?
ip route 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx track 1 ( Used at the moment with Static ISP from ISP )
We have a second site with no Static IP from ...
Hi,
I deleted the default profile 1 to do a test, but now I can't change it anymore and I can't creater a profile 2 for example.
Please help me to fix that.
Here is what it look like if i tried to modify the profile 1
-----------------------------...
Hi
Before i add the Dialer 1 configuration for WAN-1 PPPOE internet access the Cellolar 0 interface working well.
When I add the Dialer 1 Interface Config and I plug it to the DSL modem, now the primary internet WAN-1 (PPPOE) is working but
look like...
Hi,
After i deleted default profile 1 with the command bellow, look like that some thing doesn't work.
Now i not be able to recreate the profile or create a new one with the same APN
Look like that some thing doesn't work.
Is the only way to correc...
Hi,
short story, I installed on a site a cisco 819G with pre configured working cellular 0 interface like WAN-2 Backup.
On site I finalyse the config for the WAN-1 primary. Working.
The issues is that I did not test the failover on site , but now i...
Thank You for your reply,
I already tried but doesn't work see bellow the warning when I tried the command:
(config)#ip route 0.0.0.0 0.0.0.0 GigabitEthernet0 track 3%Default route without gateway, if not a point-to-point interface, may impact perfor...
Hi Georg,
I remove the 3 permanent route but nothing change.
I need for sure the 2 Permanent route
ip route 195.46.39.39 255.255.255.255 Dialer1 permanent
ip route 216.146.35.35 255.255.255.255 Dialer1 permanent
to force the IPSLA to pass by the Di...
Please see the attached configuration file.
At the moment this router is in operation on WAN-1 and everything is working.
Short Story, At the office with first configuration everything was working on cellular 0 interface and tested.
On Site We add...
I already tried and change nothing.
See the message bellow and part of my actual config. everything was working before I deleted the profile 1 to recreate it to do a test.
Now profile 1 = UNDEFINED ( Usualy it display ACTIVE or INACTIVE )
I Tried ...
Thank you Philip,
How can I enable the interface cellular 0 to stay always HOT.
What is missing on my config ?
Thank You !
Part of the Config ( See the attached file for complete config )
chat-script lte "" "AT!CALL" TIMEOUT 20 "OK"
controller Cell...
