We have a campus environment with 21 AIR-AP1231G-A-K9 access points. Each AP is configured for 4 VLANs and the firmware is 12.2(15)XR2. We are also using one of these APs for WDS and we have an ACS authentication server. Currently the VLANs are...
We have 2 WLSE's (2.9) that are redundant. Frequently throughout the day they generate the following messages via email notification:Lost connectivity with standby on 10.170.100.XXRegained connectivity with standby on 10.170.100.XXDoes anyone know w...
Hi, looking for an external 802.11a antenna that would connect off of the "a" module we insert into a Cisco 1220 "g" access point. Are any out there?Thanks.
We have recently upgrade 17 cisco 350 AP's running 12.01 T1 VxWorks to IOS 12.2(13) JA1 via WLSE 2.7.1The upgrade was a struggle but all were finally upgraded. We are now noticing that these upgraded AP's are frequently leaving the network and have ...
I have setup WPA on a Cisco 1231g AP running 12.2(15) firmware. I cannot seem to connect with a laptop and Cisco 350 card. If I disable WPA it works. Are these cards compatible with WPA?Thanks.
If you want to change power on the 2.4 GHz radio, you need to go to GUI, select wireless/802.11 b/g/n/select configure radio tab to the right/Set radio role assignment to "manual" and apply. Now go back and change power to custom and enter power lev...
We are also using 5 GHz only, but Zebra and Honeywell have suggested disabling UNII-2 and also 802.11ac. Their statement is that the VC70's and 9290' cannot perform 802.11ac. Perhaps they can with manual intervention, but that has not been tried yet...
I think Cisco has really dropped the ball on this one. Brand new 1562's in the ceiling and you need to console into them to fix the issue? That is not acceptable.