Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,Is there a way to implement policy based routing in mpls..Basically, I only want the Loopback's advertised within the core not the point-2-point links..Is this possible??I don't think so, just a simple question..PR
Hello Everyone,Having a discussion with my co-workers about "originating a default route"..Here is the scenario:Let's say that within an ISP Network, there are 2 routers that act as the edge..And 2 normal routers just below them that have iBGP sessio...
Hello,I have a question..The situation is as follows..In a IP Network where 2 MGW speak to each other with SIP, H.248, RTP signalling, I'm noticing that whenever our IP backbone has a fault or if they "change there link metrics" all the calls of o...
Hello Everyone,Just want to know if I got this right...In terms of OSPFCan we say, that when a PE router receives MP-BGP update destined for a OSPF area it redistributes these routes into the OSPF Areawith the down bit set which when received by the ...
Hello Everyong,I'm trying to create a port-channel on my cisco 12K router and getting this error message.Could some explain to me why this isn't working?12Kconfig)#interface GigabitEthernet5/1/012K(config-if)#channel-group 2Error: not supported on ...
Hey Martin,I appreciate the link and based on the link that you sent me, I think option 1 on my old post would be best approach..Is this were you trying to get at??Was I clear on my above description...Mav
Peter,I think I got it... The reason you don't see the routing bit on any of the RFC's is because the routing bit is an Cisco OSPF extension..All the routes that originated in the MP-BGP backbone need to be selected as the best path, which the DN-Bit...
