Hi All!
I got dragged into a partly configured project & am trying to piece together what's needed
*UPDATE because I worded this poorly
Network:
Firewall -> Aggregate C3850-S
-> Trunk -> (A) C3850-S
-> Trunk -> (...
Tried this - Using Vlan 99 instead of Vlan 1 per recommendation
Firewall - Vlan 99 - 192.168.99.1/24
Switches - Vlan 99 to all the switches & allowed on the trunk ports
The Switches would not apply default routes to 192.168.99.1 unless I had int v...
The firewall is an active production unit - Full internet access
There is no issue with Nat/pat
The firewall interface can be configured with any IP or as a VLAN trunk - the problem is getting the default gateway of the many Vlans to the firewall
So to double check
Vlan 1 on all of the switches
Set Vlan 1 GW (192.168.1.1) on the firewall
IP default route from the switches to the 192.168.1.1
Does that seem correct? I normally would set up all gateways on the firewall (router) so this config ...
Switches all are trunk ports they allow their Vlan connections - the only common Vlan is vlan 1
The Aggregate switch to the Firewall is Trunk allow Vlan all
