Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,
I am not able to understand how to enable the 4 switch ports in my 1815i. I am using this AP as ME controller for another one 2602. As the 2602 is old I am able to support only up to 8.5 with no issues.
But there is also a bad side. I am ...
Hello Community,
I have two APs on is a bit older - AIRCAP2602-l-i-k9 and the other is AIR-AP1815W-E-K9. First I bought the 1815 with the idea to run it as a controller for my network, but turned out the console cable for this bad boy is hard to find...
Thank you, I had a feeling that is the situation. Did all I could from the console and all my efforts were for nothing.
I found a cheap 3700 and ordered it today. Should be here the day after tomorrow and hopefully everything will be able to set up s...
Ok so I got to the point where it works on version 8.5.182.
I have two access points the 1851 as controller and the 2600 as subordinate. In the guy I don't have the option to configure the RLAN (only WLAN) and no option for AP group where I was able ...
Hello, I was able to somehow reset the 1815 and get it to broadcast the SSID. Then I was able to set it up as controller. I was able to downgrade it to 8.5.182 as this is the version that the other one was able to support, but now I am facing new iss...
But both of my APs are already running ME and are connected to vWLC.
What I am trying to do is make one of them the WLC so I don't need to run a separate vWLC. I kinda understand that I am not able to run the 2602 as ME(oddly enough it runs ME softw...
