Pratik Prajapati
Level 1
Level 1
Member since ‎03-04-2011
‎06-09-2020

User Statistics

  • 78 Posts
  • 1 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
First Discussion
70 Discussion Posts
40 Discussion Posts
40 Replies
5 Discussion Posts
50 Discussion Posts
30 Replies
30 Discussion Posts
60 Discussion Posts
20 Discussion Posts
Certifications

User Activity

I am running latest 9.8.1 code. I need assistance in allowing traffic from lower security level to higher. Below is the config. Interface g0/1nameif insidesecurity-level 100ip address 10.20.5.1 255.255.255.0 standby 10.20.5.2 interface g0/2nameif DMZ...
I have a 3560 switch and have multiple vlans on it. I need to prioritize traffic for vlan 20. How do I go about doing that? It is for AV equipments. I don't have any DSCP values but I am assuming its 46.
I have 3560 switches acting in L3 mode. There are multiple VLAN interfaces defined on it. The switch has ASA as the default gateway. Clients use default respective VLAN interfaces as their Default Gateway. User VLAN is the inside interface on ASA wit...
"For HSRP circuits, it is a requirement that Datacenter use the first 3 available IPs in the routing network. Datacenter must assign 1.1.1.66 to one of our routers.1.1.1.68-1.1.1.70 are the only IPs your company can use on the routing network.The usa...
I have a Server 2012 R2 HyperV cluster with 3 servers and a Cisco 3560 Switch. I am trying to configure trunk between HyperV server and switch ports. Below is what I have.interface Port-channel10 description  VM Internet switchport trunk encapsulatio...
Community Statistics
Member Since ‎03-04-2011 07:00 AM
Date Last Visited ‎06-09-2020 07:23 AM
Posts 78