Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am running out of IP address on our internal LAN (10.165.11.0/24). I cannot simply change the net mask to /23 since we are already using 10.165.10.0/24 in the DMZ. So, to be able to get the extra IPs needed, I've created a superscope on the Windows...
Hi everyone!I have an ASA-5510. A "sh ver" displays the results below.Question: It says that it can have a maximum of 50 VLANs but a Base license only allows for 3 VLANs... How many do I really have available?Tnaks!Cisco Adaptive Security Appliance S...
Good morning!I’m a little stumped as to why this isn’t working… That's probably because I'm not too savvy when it comes to router configs!Basically, I have a network which has a LAN and a DMZ. Everything on my network works correctly and communicatio...
Hi to all the helpful people in this community!I'm still in the learning phase with my ASA 5510 but have been able to switch from my PIX to the ASA thanks to the communitiy's help!My next issue is with our video-conferencing system. I have set up the...
Good morning to all!We are in the process of transitioning from one ISP to another. We’ll be changing our public IP addresses from 168.xx.xx.0/24 to 204.xx.xx.16/28 as well as replacing a PIX 515 with an ASA-5510. All of the public DNS entries still ...
Thanks for the suggestion!
I had thought about using the extra port on the ASA but was thinking about keeping it available should there be any kind of addition to the network.
Nonetheless, I configured it for the .21 network and got rid of the 0/1.2 ...
Ok... Lets say I scrap the whole VLAN4 config entries that I've made on the switch and ASA. I'll pretend it never existed and start from scratch!Exactly what entries should be made on both the switch and ASA so that a computer connected to VLAN4 can:...
Thanks for the suggestions!@andrewswansonI had a PIX 515 in place before the ASA but I didn’t do a migration. I configured the ASA from scratch. Being that I’m not too proficient with ASAs, and I was on a tight schedule during Christmas break, there ...
