Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I had configured an 871 to use PPPoE before. Now I tried to use the same configuration on a new 881, I was able to connect to the Internet from the router, but my PC behind the 881 cannot ping any public address except the one on the WAN interfac...
Hi, I have a seemingly simple problem, wonder if anyone has a solution. I registered all 6 lines of my 7960 SIP phone under one extension. When a second call comes in, it is laid on top of (and covers) the first call on the screen. I'd prefer to have...
Thank you very much, apparently with the new firmware ip nat outside needs to be under the Dialer interface. I ended up installing CCP on my PC and using that to generate the basic commands.
Thank you, I will try that when I get to the office next week. I did type in pppoe enable group global, but when I ran "show running-config" this line was not shown, I was wondering why. I assumed it was the default. I also tried changing Dialer1 to ...
Thank you for your reply, I did have that in there, somehow I didn't paste that in the post above: ip nat inside ip virtual-reassembly ip route-cache flow ip tcp adjust-mss 1452I started with a working configuration for DHCP and modified the WAN inte...
