Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Looking to allocate 50+ IP addresses from a Cisco 9300 XE IOS switch configured as a DHCP server.I had planned to create static IP-to-MAC mappings with the infinite option for each device.Is there an affective method of creating a list rather than...
Hi,I have connected 2 Cisco 9300 switches directly using a L2 LACP Portchannel (Active/Active), both running PVST+. If all other switch port interfaces are for hosts (spanning tree portfast) do I need STP other than the default PVST+?Thanks in advan...
Hi,I need to create LACP L2 Portchannels between Cisco switches and a Check Point Firewall cluster bonded interfaces and a Palo Alto cluster.Each separate Portchannel will be configured as 802.1q trunks.The switches are using PVST+, do I need to appl...
HiI have 2 x Cisco 9500 switches Cisco SFP-10G-R= back to back with a 3 meters fiber patch cord connected directly and Cisco SFP-10G-R= inserted at both sides only for testing.Please can anybody advise what fiber attenuators I need connect one or bot...
Hi,After Day 0 onboarding my switches, the config output displays no IP, Mask or Gateway info only ip dhcp client client-id ascii under the SVI.Please can someone provide a solution to remedy this?Would a simple variable Day N rectify and if possible...
hiDo I need to connect the db attenuators on the receive side of each end of the SFPs?Even with attenuators installed can I use a 3 metre data cord between devices?
Hi Leo,Cisco GLC-GE-100LX SFPs are MMF, FS make these for SMF but, cant use as need TAC support and wont accepted non Cisco hardware.My only solution is a Cisco GLC-FE-100LX and a fibre port switch model such as a Cisco ie3300 and add a IEM-3300-8S m...
