About geotech333

geotech333 · 07-20-2010

Hello all.I have created a management vlan on my 4506. There are also other SVIs for other VLANs. I understand configuring access-lists for the management vlan as well as for all vty lines limiting to an IT VLAN for example. How can I remove telnet ...

geotech333 · 06-14-2010

Hi all,I am still not proficient with the ASA as I would like to be.I have inherited an ASA with an AnyConnect IP Pool 192.168.6.1 - .254. Now currently the address pool is on the same VLAN as the inside interface, 192.168.0.20/21. Now that whole VLA...

geotech333 · 04-14-2010

Hi all.I have a 3750 switch stack that has had very minimal config changes over the past year.In an attempt to locate user ports by cross-referencing the ARP and MAC tables I noticed that I only have 2 entries in the ARP table.Both are for SVIs. Howe...

geotech333 · 04-13-2010

Hi all.I have a site-to-site IPSEC VPN running between a 5510(HQ) and 5505(Remote). All is working on the tunnel. Crypto maps and ACLs are symmetrical. I see the tunnel is up for the required subnets. However I cannot ping from internal subnets insid...

geotech333 · 11-23-2009

Hey all.I am configuring a 7204 with two DS3 circuits that are being channelized into 28 T1s each. I want to make sure I have them configured correctly before I start turning up circuits.I have done research but connot find anything for multiple DS3s...

geotech333 · 06-18-2010

Just recently merged networks with a huge company that acquired ours.Since we were both running OSPF and had overlapping subnets, we created an EIGRP environment in between. We created redistribution route-maps and NATed towards both OSPF backbones. ...

geotech333 · 06-15-2010

Thanks so much for the document.I will give it a shot.

geotech333 · 04-14-2010

No. It is not.I have a 6509 with all our SVIs.But your question led me to check the 6509 and all the ARP entries I am looking for are there.Still weird that in the past I had not have had to do this.Thanks for your help!

geotech333 · 04-13-2010

You the man Federico!Thanks for the quick reply!That worked!!!

geotech333 · 04-13-2010

Also to add....I can ping all 5510 inside subnets from clients on the 5505 LAN. Just cant from the 5505 itself via the ping inside x.x.x.x command.I also can't ping the remote 5505 LAN from anywhere inside the 5510. Makes sense?

Member Since	‎06-21-2007 01:27 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	15
Total Helpful Votes Received	5

User Statistics

User Activity

network management security - Switches and SVIs

AnyConnect ip pool change

Do you know what would cause a consistently empty ARP table?

Site-to-Site VPN - Can't ping remote subnet

Channelizing DS3s - Channel-Group question

Re: How to integrate two organizations

Re: AnyConnect ip pool change

Re: Do you know what would cause a consistently empty ARP table?

Re: Site-to-Site VPN - Can't ping remote subnet

Re: Site-to-Site VPN - Can't ping remote subnet