Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
from the Meraki dashboard tool. i see there is an option for adding a syslog server.IS there an option to send snmp traps also? Where is that configured?Is there a way to do this globally or do i have to do this per device?
what was the issue? I am dead in the water with this issue and it looks to me to be AD but my guys are not looking too deep. If you can state what the issue was, it would be helpful
Same Question here. I am building a new hospital and like the IA switches, need UPOE power though. I know the 3800 and 4500's support this, but I REALLY like the catalyst 6k line of devices and would prefer to use these.
Are you using a controller? I have 50K users that auth via ad on our wirless. this is what I use:Access Service:Default Network AccessIdentity Store:AD1Authorization Profiles:Mevo-auth-profileCTS Security Group: Authentication Method:PEAP(EAP-MSCHAPv...
What I have done so far is to set up an ssid which uses AD auth to verify use membership to log into this ssid.This is a byod ssid.Problem being the same users can using their same credential login into my trusted ssid using their ad credentials.I n...
What I have done so far is to set up an ssid which uses AD auth to verify use membership to log into this ssid.This is a byod ssid.Problem being the same users can using their same credential login into my trusted ssid using their ad credentials.I n...
