Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am currently tried to configure these NIM-4E/M cards using dial peer commands. Does anyone know why session protocol doesn't' given me the option to use multicast. I am can only select Cisco or SIPv2.
I have a SUN server that uses a remote SIT server to get OS images from. The SUN server resides on a LAN, the SIT server resides on another LAN. There are two routers between the two LAN. The SUN server sends out a L2 broadcast to get it's IP address...
Hi there, Can some give me detail instructions on how to configure two WIC-1DSU-T1-V2 in two different 2811 routers. I will be using a T1 crossover cable but I'm not sure if I need to configure the following entries for the serial interface:Interfa...
I have two networks, with one router in between (192.168.100.0 & 211.0.0.0) in which I am trying to forward a udp broadcast packets. Network 211.0.0.0 is sending out a udp broadcast message to a number of node on this network and I am simply trying t...
I've created a standard ACL on a 2960G switch in which I want to limit in-bound traffic to a node connected to this switch. The problem I'm having is once the ACl has been applied to the interface port, I can no longer send or recieve traffic from th...
Thanks so much for your response Edison!Since this is just a back to back connection with a T1 crossover do I still need lines3 and 4, since this is normally designated by the TELCO?Also I would like to limit my connection speed to only 512K. can thi...
Ok here is my running config. The last thing I tried was the IP Helper command. I also tried using the ip forward protocol udp 7501 with access-list control (7501 being the port that the UDP broadcast is being sent out). ip subnet-zerono ip source-ro...
Thanks....but I looked at this URL in great detail.I'm almost positive I've missing something that very simple. I don't think its that difficult to forward a udp broadcast. Maybe I get a copy of my running config to post on here. Again any help woul...
I'm not sure exactly what you mean...gi0/5 has a node with ip 192.168.100.31so are you saying that by applyingaccess-list 2 deny host 192.168.100.31 to gi0/5, you're denying inbound traffic with that ip?
