Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to install Cisco 3560CG switch using Smart InstalI based on Connectivity. 3560CG is connected to Cisco 4500x (IOS 03.06.00.E.152-2.E) in port 15.Here is the configuration:4500x:interface Vlan1 ip address 192.168.1.1 255.255.255.0vstack vla...
I know which device will connect to port 15. Only one type of switches will connect. I have configuration file, IOS and post install for VLAN-s. Switch on specific port receives specific configuration.
What about this:
You can configure a custom group based on the connectivity or topology of switches in a Smart Install network. For example, you would use a connectivity match to configure a group of switches that are connected to the director throug...
Did you enable TFTP of this image?
tftp-server bootflash:c3560c405ex-universalk9-tar.152-2.E.tar
tftp-server bootflash:test.txt tftp-serverbootflash:test_vlan.txt
This is still incorrect. How will the switch know what model this is meant to be?
...
I'm not using VStack built-in group but Vstack custom group.vstack group custom test connectivity image bootflash:c3560c405ex-universalk9-tar.152-2.E.tar config bootflash:test.txt script bootflash:test_vlan.txt
