Hello,Is it possible to configure the RTP portnumber range for an Mediatermination Point on the  IOS or on the CUCM?I think this is hardcoded so that is not possible to change.Any suggestions?Kind Regards,Dirk

Hello,we have configure DMVPN and NAT overload on the same physical Interface. We have one interface connected to the internet and only one public IP address.Everthing works fine, but after a few days the DMVPN Session terminates and only will come u...

Hi,I have following szenario:I want to reach a outside host under its original address and its NAT address at it seems to the inside world.(Host in the DMZ ist translated to the Inside Interface with a Static NAT rule).It is possible to reach this ho...

Hello,how can I configure a cisco Router for simultaneous ISDN DUN Dialin with the same Username and Password?I think this will work with virtual-template Profiles?Is this possible if I use also Dialer Profiles in the Router Configuration?Regards,Dir...

Hi,we have a 3-DES IPSEC LAN-2-LAN between a Pix 501 and a VPN3005.The Pix has a 50 User Licence, 20 Devices are active on the LAN connected to the pix.We use a Thin Client Manager program (at the VPN 3005 site), scanning the Pix LAN segment using UD...