Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have a H-REAP setup with 2 SSIDs "WLAN_Secure" and "WLAN_Guest".The controllers are running version 5.2The WLAN_Secure works fine for all users, but in a remote site the guest users can't associate to the "Guest" network.The guest network us...
Hi All,I'm having problems with the DHCP assignments to the guest wireless users in a site.I'm using a H-REAP setup with 3 WLCs and a number of APs that support H-REAP(1140, 1240).The remote sites are spread all over Europe.One of the WLC is used as ...
Dear All,We have an AIR-LAP1142N-E-K9 deployed in a H-REAP setup.This AP already got the configuration from the WLC when it was deployed at a remote site.Now we moved it to another site, but it doesn't appear in the WCS and i don't see any CAPWAP de...
Hi,No, i haven't received a response that works for my case.I had to send the AP back to the site from where it got his configs and reset it from the WCS.I'll note your solution and i'll test it the next time i encounter an issue like this one.Thanks...
Hi,After the reset to factory defaults, the AP boots with the /c1140-rcvk9w8-mx image, as you can see below.Problem is, the configuration isn't deleted.button pressed for 9 secondsprocess_config_recovery: set IP address and config to default 10.0.0.1...
I can get out of the ROMMON mode, that's not the problem.Problem is that the config file is not reset to factory defaults.After the reboot you can see that it uses the old config file.It has the hostname "BEDESAP8" which was the old hostname.Also the...
I tried that reset procedure, with the MODE button pressed for 10 seconds, but it doesn't work.The enable password is not reset, i tried "Cisco" but it doesn't work.I receive the following message after releasing the button:button pressed for 9 secon...
Is there any way to clear the Lwapp config from ROMMON?I tried yesterday to use the "Cisco" as the enable password, but it didn't work.I will try also today, and i will capture the complete logs from Putty.
