Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone
I have the topology like you can see on the attached file, and I can't reach R3 from R5
and CAT2 can reach the hole network..
for ex, R5 can not reach loopback 172.16.3.3 of R3
routing table of the CAT-2- for 172.16.3.3: --------------...
Hi everyone
so I'm testing the L3 etherchannel gigaethernet interfaces
and the L3 etherchannel refuse to come up
here is my config
--------------switch 1 --------------
interface GigabitEthernet0/2 no switchport no ip address no negotiation auto ch...
Hi Everyone
I have a DMVPN Topology, and while configuring the GRE tunnel interface, I have this
errors appears
%ADJ-5-PARENT: Midchain parent maintenance for IP midchain out of Tunnel0, addr 16.16.16.1 - looped chain attempting to stack
and the ...
Hi Everyone
I have a problem while configuring Multiple HSRP, I have two routers, I've configured HSPR on it like this way :
-----------------------------------------------------------------------------------------------
R1#show standby Ethernet2/...
Hi Everyone
I have a simple question, I'm trying to send VTP msg via a routeur, for my topology I have two switches et between them
I have a routeur; what I'm going to do, is to create vtp domain on one of the switches, and I want to know if it's p...
hey don't wait for the fixe
it's working fine on packet tracer, and if you are using the same config as mine, it's correct, I've tried the same config on real devices and it's working.
