Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I’ve a design related question!Is the following solution feasable?A SD-WAN router is connected to the ISP via a public /30 IP subnet; the router's WAN interface is used with the IP out of this /30 to establish the tunnel! So far so good, while...
Hi,
I´d like to update a "C8300-1N1S-4T2X" firmware but I don´t know which and why I should use the respective software...
maybe somebody could help me understand the differences and use-cases when to use which of the mentioned versions?
thank you!
...
Happy new year everybody!
please allow me a question because I have some problems in the understandig of the end user behavior when it comes to access of Private Application which can be achived via Client-Based ZTNA and ones which are only available...
Hi,quick question… should the Auto-VPN tunnels also be available and shown in the Umbrella Dashboard - Network Tunnel section? In the Meraki Dashboard everything looks fine but in Umbrella nothing is visable…
Hi all,I´ve two questions about the Meraki Cloud Monitoring option for C9K Switches!1-) is AAA only possible with local Authentication or can TACACS+ through e.g. ISE also be used?2-) is it possible to use a 3rd party on-premise SNMP solution (SNMPv2...
the /29 IP-Subnet should be used directly on an Interface on the cEdge and be announced over the /30 network via eBGP! So in my thoughts this LAN Interface where a Firewall should be connected should also be in VPN0…I think in combination with DIA an...
Hi,I´m new to this kind of topic and have a question what would be the "correct" way to configure only MACsec on a Switch-to-Switch Link?Using CTS/Manual or a MKA Policy? Is there a difference in the behavior regarding security?
@Mark Malone wrote:
Even without conflict logging, there's no DHCP functionality loss and no chance of duplicate address allocation, as the router would still check whether an IP address is active before allocating it (and later on, it would be willi...
I´ve only Switches in my Network and I´m trying to integrate them via SNMPv3 in my NMS which is on the LAN-side but in a different VLAN/IP-Subnet... I´m not able to get the informations via SNMP - any ideas?
actually I´m also trying to understand how this scenario/design would work @Brash you mentioned that in your setup you´re using a MX in Concentrator mode acting as Hub next to the Umbrella SD-WAN connectors and advertising IP-Prefixes with the longe...
