Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I've had this issue where using web-auth with passthrough with a redirect to URL. After the Accept button, the popup window to the redirected page appears, but closes itself immediately afterwards with SSID successfully logged in. However I ne...
I have an WSA S170 (Async 9), ISE (v2.0), Active Directory, WCCP router, no CDA server With HTTP traffic, I believe it is doable for transparent authentication (WSA > ISE)However for HTTPS traffic, whereby the WSA should have a browser prompt for use...
Hi All, I've found the issue. Not Cisco WLC related.. but I wish it was explained better.Basically the Web-Auth Passthrough on newer phones will prompt the mini-browser, instead of the usual full-fledged browser. Upon detecting Internet access, this ...
Thanks for the replies, but sorry guys, we'd tried to switch back to WLC2 and its also like that now. We had rebooted both.I don't assume this is the normal behaviour though? Or what config is needed to make the redirect page stay on?
hi amojarra,i think my version does not have this option.. for authentication realms are given as Kerberos and LDAP only. ISE is a separate section by itself. Asked my question specifically for Async 9.0, as I am in a situation with no possible means...
thanks Robif directly reading from the diagram, WSA should purely rely on ISE for identifying user-IP mappings.I guess the next question would be.. does the ISE also use SMBv1 to connect with AD?
