Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I would like to enable QoS on a Cisco 857 router so I can give priority to VOIP traffic. I have not done this before, so wondered whether someone could point me in the direction of a good guide on this can be achieved.I have also read in different...
Hi,I have a Cisco 857 router. I have an internal ip address to which I want to direct traffic from an external source.The internal IP address is 192.168.2.50. Previously I have translated a single port to this address, I did this by adding a line to ...
Hi,I have connected a Cisco 857 router to an ADSL line. Internet worked for a while, then the connection started dropping. I have tested with a different router (a Netgear) and the connection is stable. The line is adsl 2+, and I have loaded the lat...
I have two offices which are linked by a vpn connection using Cisco 857 routers. The broadband connection isn't very reliable, so both offices have had a second broadband line installed (through a different ISP).Each office now has two cisco routers,...
Hi,Just over a week ago this forum helped to resolve a problem whereby a Cisco 857 could not connect to the internet following an upgrade to ADSL2+The router was working fine, then dropped the connection. The router is no longer connecting, yet when ...
Hi John,Thanks for the info. If I add the line:ip nat inside source static 192.168.2.50 interface Dialer0What effect will this have on traffic coming in to the external interface? Will it forward all traffic to 192.168.2.50, or just make the external...
Hi Giuseppe The Cisco router lost the connection again on Monday, so we had to swap it for the Netgear again.I have attached the output of "sh dsl int atm0" which was taken this morning. At the time, the Cisco was unable to connect. Swapping to the N...
Hi,We went out to this customer today. I have attached the Netgear stats. Strangely, when we connected up the Cisco, it worked! We have left it in place over the weekend, so will see how it has coped on Monday.
