Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a 4 ACS server beside a FWSM, and i can´t reach one of these 4 server on port 61616 from outside the protected area. ACL are correctly in place. I have create a loopback with source IP in the switch the FWSM belongs and originate my tes...
Hi,I have a Network Analysed Module in a switch, and strangly it is not capturing anymore. It´s meet the system requierment and it was working just fine 2 weeks ago, i have tried to clean up old capture, same issue. Error message i got is: "please ch...
Hi,i have a ACE lb and i´d like to configure request method get url but i´m not sure what are the expected result and i couldn´t found any information on cisco.com.Thanks
26051980DAO escribió:Hello!Here is a nube question:refer to a scheme:Router Eth0 <---------> Fa0/1 SwitchI enter "shutdown" command on Fa0/1 interface of a switch,after that i see from Router:router#sh int ethernet 0Ethernet0 is up, line protocol is ...
well,unless you physically disconnect the cable you´r not gonna see down down. This is quiet normal. Run a show controller and you will see the physical connection of the interface.Cheers
