Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI all,this is my first time posting a question here, so just have a little patience I have a problem with Policy Based routing on a client network. the machine is a 3560 switch on the edge of their network. behind this machine on their own network...
Hi, im configuring a vpn tunnel between 2 sites over an adsl line. Could anyone tell me how this would change both site's internet access ability?since the vpn uses the internet link to become a point-to-point link between the two sites, how will t...
I've tried loading the correct images (found from its backup routers) and tried loading the latest ios found from cisco. it just keeps on bypasing the IOS version and goes right into the rommon mode..it does show this message about 3 times before it...
Turns out that was my issue too. I was totally under the impression that the pnp feature would be built in from the start.
Got it sorted out now,
Thank you very much
Thank you very much Jonthis explains the whole situationall i have to do now is get them to make the changes - i will remove that ACL like you suggested, and make the whole config a lot easier to read for someone like me
hey, try doing it in 2 statements:#redistribute rip subnets#default-metric 10maybe that will work. if it still comes up with an error, try moving to rip version 2.
