Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello! I'm trying to put together a qos and bandwidth shaping policy on a pair of Nexus 93180 switches both running firmware 9.3(8). There are two interfaces on each switch that I'm trying to apply these policies to. Here is what I've got so far and ...
I'm migrating from an older WS-C3750X switch stack over to a C9300 switch stack. The C9300 switch stack is configured the same as the existing stack and will be racked up, stacking cabled up, and powered up alongside the existing switch. To minimize ...
Ah, yes... that was a typo on my part for the two outbound policies. I did create a new configuration with the hierarchical QoS but Nexus not allowing that is news to me. Here is what I have now:ip access-list ACL-MI-PORTS
permit tcp any any range...
"When you disconnect device from SW-A and connect it to SW-B the SW-B will treat it as new auth even if timer is not end yet."
That's actually perfect and what I want. I just wanted to make sure if I shut down the management VLAN interface on the old...
