About Raja Ali

Raja Ali · 07-20-2022

Hi All,Requesting your kind help on the below scenario testingWe have configured Public IP in one of the WAN interface 2.2.2.8 255.255.255.224Have configured loopback with below public IP2.2.2.100 255.255.255.255When i tried to ping some destination ...

Raja Ali · 07-22-2022

Thank you all for your help and support, able to figure out the issue and it is resolved now. The IP was also used by some other services, which was the cause

Raja Ali · 07-20-2022

When i do the traceroute with the loopback (2.2.2.100) as source it stops at the first hop at the router itselfHowever the with the WAN interface IP (2.2.2.8) worksDo i need to configure any specific route for the loopback IP am i missing anything he...

Raja Ali · 07-20-2022

At the remote side have configured route for both the IP's

Raja Ali · 07-20-2022

.Even though it falls on same master subner 2.2.2..0/24At WAN Interface i had configured as 2.2.2.8/27 and had used 2.2.2.100/32 at the loopback interface end.As i mentioned from outside i am able to ping both the IP. From inside with source as WAN I...

Member Since	‎07-20-2022 11:33 AM
Date Last Visited	‎07-29-2022 12:51 PM
Posts	5
Total Helpful Votes Received	15

User Statistics

User Activity

Loopback Interface with public IP

Re: Loopback Interface with public IP

Re: Loopback Interface with public IP

Re: Loopback Interface with public IP

Re: Loopback Interface with public IP