Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I'm configuring MAB for some devices on Cisco 9300 switches (IOS-XE 17.03.04).For authentication I am using microsoft NPS server. The whole thing is working fine, but i want to ask if there's a way to tweak the periodic accounting updates...
Hi,
this is my very simple topology in VIRL:
IOSvL2 (running IP routing) <-----trunk with VLANs allowed + Native VLAN----> IOSvL2 (NO IP routing) <----> 2 hosts on different VLANs
The interfaces connecting the hosts are standard issue access ports wi...
Hi,Short and simple question just to clear some doubt.Is it possible to advertise a VRRP/HSRP virtual IP over an IGP such as OSPF? Or is the only way to reach this IP by configuring a static route to it?Thank you.
I see... so I used the command
sudo ip route add 10.0.151.254 dev ens2
to set the DG. Just entered your command and that worked straight away.
slightly embarrassed but at least have learned something.
Thanks @Harold Ritter
hi @paul driver yes both hosts are attached to the same L2 switch and I did configure the VLANs manually.the actual topology is bigger and am satisfied that the OSPF is working fine between all the router devices across the whole topology. However, I...
