Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Failed established Anyconnect management tunnel from the client and shows invalid vpn configuration as below.ASA logs as below and shows this error SVC Message: 16/ERROR: Configuration received from secure gateway was invalid.Could someone please sha...
Dear All, I am following below link to setup anyconnect management VPN tunnelhttps://www.cisco.com/c/en/us/support/docs/security/adaptive-security-appliance-asa-software/215442-configure-anyconnect-management-vpn-tunn.htmlMy ASA version : 9.16 , ASD...
Dear All,It was easy to understand the most of the basic networking concepts with few devices(PC1--SW1--R1--R2--SW2--PC2) in GNS3.Can some one please let me know if there is a way to start learning SD WAN in similar way.
Dear All,Can someone please recommend versions suitable for an enterprise network? Below are some of our requirements1. Control per-user bandwidth(allocate 10mbps for each client IP)2. Allocate bandwidth per URL/IP outside3. Limiting email attachment...
Thanks balaji, please find the attached config simulated to outside interface.I can ping inside network when I connect VPN4 with user cetificate, but Management_Tunnel still same issue.
Thanks @Joseph W. Doherty , if I have three sub interface, two sub interface need 20mbps youtube(common) and one sub interface need 30mbps youtube. remaining bandwidth for other traffic 450mbps( 500-(20+30)), sorry to ask for many combinations.
